Abb acs 600 hardware manual

ID: 3AXD REV: F. ID: 4FPS REV: G. ACS Multidrive air-cooled - lifecycle Information. REV: C. REV: B. Modernization for ACS single drives brochure. REV: A. ACS recycling instructions. ID: 3AFE PART: 1. REV: D. ACS Instructions on how to handle an end-of-life product.

Recycling instructions. Intended for United States only. Service instruction. Maintenance Schedule for ACS REV: K. ID: 3AFY REV: E. Contents: installation, commissioning of the drive section, maintenance. ACS Recycling instructions. After adjusting the voltage put the plate back into its place. Loosen the lead-through plate position screws. Pull the two parts apart.

Page 35 Chapter 3 — Electrical Installation b. If the outer surface of the screen is covered with non-conductive material figure below Stripped cable Conductive surface of Stripped part covered the screen turned visible with copper foil Copper foil Cable screen Screened twisted pair Earthing wire - Cut the screen in the middle of the bare part.

It is advisable to go through the checklist below together with another person. Study carefully the Safety Instructions on the first pages of this manual before attempting any work on, or with, the unit. Check that there are no tools or other foreign objects inside the cabinet. With bypass connection, check that mains voltage cannot be applied to the output of the ACx Page Chapter 5 - Maintenance Capacitor failure is usually followed by a mains fuse failure or a Fault trip.

Contact ABB if capacitor failure is suspected. Replacements are available from ABB. Do not attempt operation with other than ABB specified spare parts. The ACx is to be installed in a cabinet by the user. Symbols are described on previous page. Page Efficiency And Cooling At sites over m ft. If the installation site is higher than m ft.

The capability is specified based on wire lug that the terminal accepts according to DIN for copper cables and DIN for aluminium cables , cable cross section that will fit through the European lead-through plate hole, and maximum electrically needed For terms used see above.

Refer to Chapter 2 for the ACS type code description. External control connections are different with other application macros and programs see Firmware Manual. External control connections with Factory Macro are shown below.

Connections are different with other application macros see Firmware Manual. External control connections are different with other application macros see Firmware Manual. One application program at a time can be loaded in the memory of the frequency converter. Safety of machinery.

Electrical equipment of machines. Part 1: General requirements. Provisions for compliance: The final assembler of the machine is Page Ce Marking 2. Note: It is recommended to equip the ACx with the EMC filtering if there is equipment sensitive to conducted emission connected to the same supply transformer as the ACx Page Machinery Directive V ACS is suitable for use in a circuit capable of delivering not more than 65 kA rms symmetrical amperes at V maximum V units , and at V maximum V units.

All clauses of action against ABB arising out of or relating to the contract or the performance or breach hereof shall expire unless brought within one year of the time of accrual thereof. These terms are available on request. If you have any questions concerning your ABB frequency converter, please contact the local distributor or ABB office.

Print page 1 Print document 94 pages. Rename the bookmark. Delete bookmark? Cancel Delete. Delete from my manuals? Sign In OR. Don't have an account? Sign up!