Zetor 3340 manual

JavaScript seems to be disabled in your browser. For the best experience on our site, be sure to turn on Javascript in your browser. Power train. Final drive and rear axle Front axle Front driving axle. Air brakes and dismantling of front Power Take-Off P. Hydraulic system.

Tie rods and suspensions Electrical system Tractor body and structure Sea ts. Ballast weights. List of bearings, packing rings and service tools Dismantling and re-assembling, including repairs, should always be carried out using suitable and high-grade tools or using our set of service tools, Part No. The parts pressed on or heat- assembled should be dismantled only by pressing or using a suit- able mandrel. The contact surfa- ces of parts to be pressed in or shrink on should always be coated with oil properly.

Take care to re-assemble, as the case may be, all the disman - tled parts to their original pla- ces. It is especially important to follow this rule in the case of repeated use of the bearing needles and rollers. Clean properly all the parts before assembly and coat their contact surfaces, and espe c ially the friction ones, by oil, grease or sealing compound. Check it for damage. It should be immersed into oil or coated by oil before assembling. Fill the ring inside with grease after assembling.

Paper gaskets , rubber and cork packings and seals, fuses, wires, r etaini ng rings, cotter pins and similar parts should be replaced by new ones. Take care to fill up all the repaired groups components with oil or grease before putting into service. When using a crane, check to be sure the crane lifting power and the loading capacities of ropes and suspensions are suf- ficient when compared with the load in question.

Use an appro- priate lifting gear only. Use suitable plugs to blind the open holes of parts or ends of pipelines disconnected. Insu- late the disconnected ends of electric wires and mark them un- less provided with numbering. In addition, since to , the Zetor company produced the Zetor compact tracked garden tractors with a two-cylinder engine. The result of the year activity of the company Zetor was the release of 1. The amount of investment in the development of the production of the Czech company amounted to one hundred million dollars over the past five years.

Zetor Tractor logo. Zetor Major hs Zetor Proxima HS We Use Cookie We use cookies on our website to give you the most relevant experience by remembering your preferences and repeat visits.

Manage consent. Close Privacy Overview This website uses cookies to improve your experience while you navigate through the website. Out of these, the cookies that are categorized as necessary are stored on your browser as they are essential for the working of basic functionalities of the website. We also use third-party cookies that help us analyze and understand how you use this website.

These cookies will be stored in your browser only with your consent. You also have the option to opt-out of these cookies.